Most of the time the problem stems from dirty and dried up rollers.
Keeping sliding doors from rocking.
Screw the strike plate back in place check the door and adjust if needed.
Http amzn to 2eijbrx dry spray lubricant http goo gl 4eydkq click link to order sliding door lubricant.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
Then secure the door stop with 1 1 4 in.
Turning this screw raises or lowers the roller.
If the right side of the level is raised to equal a level position the right front foot of the washing.
Close the door and hold a block of wood against the doorstop.
If the door becomes even harder to open turn the screw in the opposite direction.
These rollers can become damaged dirty or broken as the years go by and cause your door to stick.
Watch the video above to see joe s simple solution.
To fix this remove your door from the tracks clean out the rollers and spray them with a lubricant such as wd 40.
Sliding doors operate in a very simple manner.
They move along a set of tracks that are made of vinyl metal or wood.
Visualize the tracks as guidelines that show the door where to move.
Sliding doors move along the tracks using a set of rollers.
Proper installation of bottom guides.
The bottom guide is barn door hardware that plays a critical role.
These can be found on both wooden and glass barn doors.
Or bend the tang gently.
For your average diyer installing a barn door can be a learning experience to put it mildly.
You will find a nut on the hanger of your pocket.
Give the screw a clockwise turn and test to see whether the door slides easier.
It s sole purpose it to keep sliding barn doors moving in a straight line.
To stop a door from rattling when it s closed remove the strike plate and bend the metal tab forward slightly using pliers so the latch fits securely in the strike plate.
It keeps barn doors from swinging out of place and causing damage to baseboards and walls.
Tighten one adjustable wrench onto the curved latch side of the plate to hold it while you bend the tang.
You should double check both hangers since you have total access at this point.
But what about after you ve installed the door.
Smack the wood until the door stop moves enough to touch the door.
Lift the left or right side of the level until the bubble is in the center level position.
To adjust the door you will need to have a wrench handy to adjust the hangers on the door.